Ok, I understand
Cookie Notice: This site uses cookies. For more information, please see our privacy policy.
Skip to main content

Paignton Torbay Bowling Club

Short Mat Bowls

The Club has purchased a new Short Mat for use of members during the Winter months.

It is available to use in the clubhouse on Thursday and Fridays.

Partially sighted members have a session booked between10.30am and 12.30pm each Thursday but

all members are also invited to participate.

A Quick Guide to Short Mat Bowls

Short mat bowls is based on the outdoor sport of lawn bowls so many of the rules are adaptations of the rules of the outdoor game with the basic aim being to deliver as many woods (bowls) as possible nearer to the smaller target bowl (the jack) than any of the opposition’s woods.

The notes below are intended to give an introductory outline of the game. Full rules can be found in the ESMBA Laws & Rules booklet but, like any other sport, you can only really learn by going along to your local club and giving it a go.

Format of the Game

The game is played by two teams of 1 (Singles), 2 (Pairs), 3 (Triples) or 4 (Fours) players per side. Woods are delivered alternately by each team with each team member delivering all of their woods before the next team member takes their turn. The usual playing formats in the different disciplines are as follows:

Singles - 4 woods per player

Pairs - 2 or 3 woods per player depending on the competition

Triples - 2 woods per player

Fours - 2 woods per player

The game is played over a pre-determined number of ends (played up and down the mat) which will depend on the time available or the competition rules.

Each team, depending on the format, will comprise players in some or all of the following positions:

Lead    The first player to play, the lead’s role is usually to deliver woods as close as possible to the jack. A good lead will be able to consistently ‘draw’ woods to different jack positions

Two     The Two (or Second) is the next player to play and, as well as an ability to draw woods to the jack, is more likely than the lead to be required to use additional ‘weight’ (woods bowled with more power) to move a wood in the ‘head’ (the area and woods around the jack) or to disturb an opposition bowl which is currently holding ‘shot’ (nearest to the jack). In a Triples game the Two fulfils some of the duties of the Three in a Fours game.

Three    The  Three (or Third) could be required to play any type of shot and requires a full range of shot-making abilities. The Third also takes responsibility for agreeing the final result of the end with the opposing Three and for measuring where necessary. The Three provides information to the Skip from the head end of the mat when it is the Skip’s turn to bowl.

Skip    The Skip is, effectively, the captain of the team and directs the other team members as to what shots he wants them to play throughout the game. The Skip remains at the head end of the mat until his turn to bowl and also communicates the situation at the head to his team-mates as they bowl. The Skip plays the final woods of the end and needs to be able to play a full range of shots depending on the situation.

The Mat

The pre-marked mat is 6 feet wide and between 40 and 45 feet long. A white wooden block is placed on the line across the centre of the mat. This block prevents direct firing shots down the middle of the mat and forces the use of a wood’s bias, at least until the jack is moved to the outer edges of the mat during play. At each end of the mat is a wooden fender which defines the limits of the ditch area and provides some protection to the players (and the hall!) from heavily bowled woods. At the beginning of each end a rubber delivery foot mat is placed in the pre-marked central position at the end of the mat that an end is to be played from and the jack is placed on the centre jack line at the opposite end of the mat.

Basics of Play

A coin toss will normally determine who bowls first in the first end and then each subsequent end is started by the winner of the previous end. The team who bowls first in an end also decides where on the centre line at the head end the jack is placed (from a ‘short’ jack at the front of the line to a ‘long’ jack furthest from the bowlers).

When delivering a bowl a player must have one foot entirely within, or above, the bounds of the delivery foot mat and the other foot within the side delivery lines. If this is not done then a foot fault occurs and the bowl is removed from the playing area. Similarly, any bowl which touches the centre block, fails to cross the far dead line or crosses the ditch line without first touching the jack is dead and is removed from the playing area. Any bowl leaving the side of the mat is dead.

If the jack is driven off the mat the end is declared dead and is replayed (or, under certain competition rules, penalty shots are awarded to the opponent and the end is counted).

If a wood is played which touches the jack before coming to rest it is declared a ‘toucher’ and is marked with chalk.

A toucher or the jack remains in play when it crosses the ditch line (non toucher woods doing so are removed). If a toucher or the jack is completely over the ditch line then it can only be moved by another toucher or the jack (in the case of a toucher). A toucher or the jack lying across the ditch line is still ‘live’ and can be moved by any wood. A toucher or jack which has completely crossed the ditch line has its position marked by chalk marks on the mat so that it can be returned to its position if it is illegally moved by a non toucher wood.

At the conclusion of an end each of a team’s woods which are nearer to the jack than any of the opponents’ woods counts as a ‘shot’. Specified measuring devices may be utilised in determining shots. Scores for each end are normally recorded on a scorecard (or one held by each team) and the cumulative scores are usually shown on a scoreboard visible to all players and spectators. The total number of shots accumulated at the end of the game determines the winner.

Woods

The woods used in short mat bowls are the same as those used for lawn bowls and are available in a wide range of standard sizes, colours and bias characteristic.

The appropriate size of wood is determined by the size of a player’s hand and advice should be sought regarding the correct size for an individual’s hand. As a general rule you should be able to touch your two thumb tips together on one side of the smooth running circumference of the wood and your two middle fingers on the opposite side. A player will usually use the largest and heaviest bowl which is comfortable.

Woods have an inbuilt bias which determines the path that the wood follows. The bias takes most effect as the wood slows towards the end of its course and the biased side of the wood is indicated by the smaller set of concentric rings on one side of the bowl. This side of the wood will usually face inwards (towards the centre block) when delivered. A ‘wrong bias’ wood is one delivered with the bias facing the wrong way to that which was intended and such a wood will normally go off the side of the mat. Different woods have different bias characteristics and for current models of wood these can be compared on charts provided by manufacturers (Click here to view bias charts). The amount of bias in woods is very much a personal choice but, as a general guide, players who regularly play Lead or Second will often choose a straighter wood with less bias whereas a Third or Skip will usually play with a more heavily biased wood which permits a greater variety of shots when the head is more crowded with woods and an uninterrupted narrower line to the jack may no longer be available.

A new player should not rush into purchasing woods. Club members will often be happy to allow new players to try their woods and it is a good idea to try out a number different makes and characteristics of wood before making a purchase. A new player may also wish to buy second-hand in the first instance so less outlay is made until you are sure of the woods which suit you.

Mats and Floors

Part of the skill of the game is due to the fact that each mat in each venue will have its own characteristics and peculiarities which need to be identified and overcome by players. Different mats can be ‘faster’ or ‘slower’ than others as a result of the texture and age of the mat and the speed of a mat is also influenced by the surface it is laid on. The underlying surface will also affect the performance of the mat as few venue floors are perfectly level and imperfections in the surface can cause ‘runs’ on the mat where woods deviate from their normal curving path or can cause a mat to have a ‘straight’ side and a ‘swinging’ side where, for instance, there is a slight gradient running across the mat which either reduces or enhances the bias of the woods. A gradient running down the mat may cause one direction to play faster than the reverse direction (effectively playing uphill and downhill). Experienced players quickly identify the peculiarities of mats and adapt their play to overcome or to utilise their characteristics.

Some Shots

Forehand    A forehand shot for a right-handed player takes the bowl to the right hand side of the centre block with the bias side of the bowl facing left (reversed for a left-handed player)

Backhand    A backhand shot for a right-handed player takes the bowl to the left hand side of the centre block with the bias side of the bowl facing right (reversed for a left-handed player)

Draw    A drawing shot is delivered with just enough weight for the wood to arrive at a pre-selected point on the mat, perhaps alongside the jack or in another tactical position requested by the Skip

(Controlled) Weight    A heavier shot intended to move a wood or the jack within or out of the head. Judgement of the correct weight to use for a particular outcome requires an understanding of the way woods behave when delivered with different weights, particularly in terms of how the bias responds, and also of how woods and the jack behave when struck in different circumstances. Mastering of weight shots requires practice and experience of different situations.

Fire    A heavy weight shot intended to move one or more woods or the jack either into the ditch or off the mat. This will usually be used when the opposition are holding shot(s) and a draw or controlled weight shot to gain shot is difficult or impossible. When it is intended to play a firing shot the player should warn the players at the head end and on adjacent mats so that appropriate action can be taken to intercept any woods that leave the side of the mat as a consequence.

Trail    A shot which is aimed at the jack but with enough weight to take the jack back to another point on the mat. This will often be used where the opposition are holding shot(s) but the player’s side has woods behind the jack which can be brought into play by moving the jack. A successful trail requires the wood to make a ‘full’ contact with the jack i.e. striking the jack with the centre of the wood in order that the jack does not deflect off to one side.

Where Can it Lead?

Many players just want to participate in short mat bowls as a social activity but the opportunities for playing competitively include club competitions, club team representation in county leagues and county team representation in the national inter county competitions. Open competitions in the various disciplines also take place at a local or county level and each county will have annual county competitions from which there is qualification for the national finals in each discipline. The larger competitions are held in venues with the capacity for many mats on which multiple matches take place concurrently, generating a much different atmosphere to the small community halls in which many local matches are held.

Paignton Torbay Bowling Club Short Mat Bowls